Configure static routing on your modem

Static routing allows you to add routers manually to the routing table.
 
Note:  If a change or a failure occurs between two nodes, traffic will not be rerouted until the problem is resolved by the administrator.
Modem Advanced Step 1-4

1.  Connect a device, such as a computer or tablet, to the internet through WiFi or using an Ethernet cable connected to your modem.

2.  Open a web browser and type http://192.168.0.1 into the web address field.

3.  Log in to the modem's online user interface (Modem GUI) using your Administrator Username and Administrator Password. Unless you have changed the default settings, you can find this information on the modem's sticker. Note that these are different from your wireless SSID and security key.

4.  Select "Advanced Setup."

5.  Select "Static Routing" in the left sidebar. 

6.  Follow the steps to edit the Static Routing settings:

  • Step 1:  Set the IP addressing type to IPv4 or IPv6.
  • Step 2:  Enter the Destination IP, Subnetmask, and Gateway IP.
  • Step 3:  Click "Apply" to save your changes.
Need more help? Contact Us

Was this article helpful?
CenturyLink Product Support
Search Support